![]() ![]() Your broadcast filtering settings are saved.Īfter you configure broadcast filtering and storm control rates on your switch, you might want to change settings for QoS, rate limits, flow control, multicast, and IGMP snooping. Your storm control rate settings are saved and the EDIT STORM CONTROL RATE page closes. To set a storm control rate limit for a port, select a rate in Kpbs or Mbps from the individual menu for that port.Click the slider below Broadcast Filtering to enable it.At the top left corner of the screen, click PRIORITIZATION.Log in to your switch by typing its IP address into the address bar of your web browser or using a saved bookmark.To configure broadcast filtering and storm control rates on your Nighthawk switch: Storm control rates are the rates at which ports on your switch allow broadcast packets to be sent. Your switch measures the rate of incoming broadcast, multicast, and unknown unicast packets per port and discards packets when the rate exceeds the allowed value. ![]() Wireshark allows you to filter the log either before the capture starts or during analysis, so you can narrow down and zero. If you want to see traffic to an external site, you need to capture the packets on the local computer. When you turn on broadcast filtering, you have the option to set the storm control rate on each port of your switch. LAN traffic is in broadcast mode, meaning a single computer with Wireshark can see traffic between two other computers. Broadcast filtering lets you limit the number of broadcast packets that each port sends. Forwarded message responses can overload network resources, slow regular network traffic, or cause the network to time out. Broadcast filtering helps to prevent a broadcast storm, which is a massive transmission of broadcast packets being sent by a single port to every port on a local area network (LAN).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |